12 volt lights

These ones are actually made by cree which is the same as the lights we already have!

Need to come up with a bracket arrangement. Would I need to keep water of them or could I just hold the spotlights at the front as you would in the ceiling?

What do ew recon? And nothing with egg boxes and rubber bands please Garry. Try to be positive if you can.

I think they'd need to be held a bit more secure than that otherwise they might shake out and smack you in the mush! you ideally need to keep the water off them too

i think you should get a local celebrity to switch them on when they are ready boy !

Gareth Gates wrote: i think you should get a local celebrity to switch them on when they are ready boy !

We'll have a ribbon cutting ceremony

Gareth Gates wrote: i think you should get a local celebrity to switch them on when they are ready boy !

Try to be productive and keep on topic if you can...

So I should look for a lightweight spotlight that uses this type of bulb?

[quote="phil990"]

Gareth Gates wrote: i think you should get a local celebrity to switch them on when they are ready boy !

Try to be productive and keep on topic if you can... [/quote

Just had a look at the down lighters in the kitchen. The clips are not very strong or stiff are they Joe? I was just thinking of mounting them to an L shaped bracket with the correct diameter holes. And then just soldering the wire directly to the prongs. Keep it really simple...

I think we've just been told off Mr Gates - and for not taking serious a man intent on fitting 3 bathroom lights to his head

and a pull switch !