Llanelli lad say Hi

Hi Richy,welcome,lots of jetting and other info on http://www.gasgasrider.org/

Hi Tilts
There's a full fmf fatboy exhaust system on it plugs like
New and I clean air filter after every outing cos my side panel
Quick realese fastener comes losse now and again ,so I try and keep
On top on the maintanace side of things, power valve is nice and clean
So I'm open to offers on what could be the problem .

Pevs I checked out the gasgasrider. Org forum and found
A link for jettin settings but I think there all USA set up.

Someone call for help

Welcome mate...

Carby problem...Take it its running ok down low to mid throttle?

What I would do is take a note of where on the roll of the throttle it bogs [already done?]

Take the carb off check the condition of the reed petals [cracks] they should ground on the block if there are any gaps change them as they may be fluttering excessivly...but realistically shes getting too much fuel oop top, so lower the needle one notch [ie moving circlip up] it should be in the mid position for best results!

Take the bike for a spin and again note any improvements...

slowly slowly is good do not alter fuelling mix to compensate...

If there is just a slight improvement then go 175 on main jet - mixture screw is generally one and a half turns out...

forgot to mention the above..

gasgas richy wrote:Thanks Wege

Where you from bud?

i,m from the sunny rhondda ,gods country

wege has spelling difficulties like most of us, I think he meant dogs country.

piggy countryoink oink

Reeds striped and checked over and cleaned they look ok
No cracks and they sit flush to the thing they fit onto you know the
Shbonka .

Costa del fecking Rhondda . i Hola!

Isla Widget . Nipper . We are experiencing a Hurricane at the moment !!!

Save our souls. Papa Tilts

Portboy29 wrote:Isla Widget . Nipper . We are experiencing a Hurricane at the moment !!!

Save our souls. Papa Tilts

Fran and mother together, what do you expect...