Swing arm bearings

View previous topic View next topic Go down

Swing arm bearings

Post by Clarky_two on Tue Jul 26, 2016 9:37 pm

Hi guys. I've bought the proactionsport swing arm bearings kit. I am having issues with it fitting back into the swing arm location on the engine block. The spacers are being pushed out by the seals. I have removed the seals and tried to fit it but it's almost like the bearings are too big. They are pressed together as far as they will go with equal distance either side to take the spacers but they still won't fit. Anyone else had any issues with this? It's difficult to measure against the old bearings as they fell apart when I took them out.

Need to get  the bike back together by Friday.
avatar
Clarky_two
Forum Sponser

Posts : 1163
Join date : 2014-09-14
Age : 45

Back to top Go down

Re: Swing arm bearings

Post by steve on Tue Jul 26, 2016 9:40 pm

I grease mine quite often and have found if i use to much grease there no way the little bastards will go back in.
avatar
steve

Posts : 4077
Join date : 2010-01-26
Age : 41

Back to top Go down

Re: Swing arm bearings

Post by Clarky_two on Tue Jul 26, 2016 9:44 pm

Ah that makes sense Steve. I did put a lot in there. Will try and get some out tomorrow
avatar
Clarky_two
Forum Sponser

Posts : 1163
Join date : 2014-09-14
Age : 45

Back to top Go down

Re: Swing arm bearings

Post by Sponsored content


Sponsored content


Back to top Go down

View previous topic View next topic Back to top

- Similar topics

 
Permissions in this forum:
You cannot reply to topics in this forum