Husqvarna te300 2014

View previous topic View next topic Go down

Husqvarna te300 2014

Post by Jonathan Williams on Mon Mar 09, 2015 7:35 pm

Recently got this bike and feel it's been jetted really rich, smokes when riding. Rode same route yesterday I used 11 litres mates ktm 300 used 9 litres. Haven't had a chance to look at carb yet. Anyone know the standard settings to try to see how it is

Jonathan Williams

Posts : 19
Join date : 2015-02-18

Back to top Go down

Re: Husqvarna te300 2014

Post by simon on Mon Mar 09, 2015 8:52 pm

Got a 14 berg te 300 that was the same, try this:
N4DK NEEDLE 2nd clip from top
165main
35 idle jet
Air screw out 1.5 turns out from fully in
Quite a few here run their 300s like this made a big difference to the fuel consumption on my bike
avatar
simon

Posts : 290
Join date : 2013-08-25
Location : South Wales

Back to top Go down

Re: Husqvarna te300 2014

Post by Jonathan Williams on Mon Mar 09, 2015 9:08 pm

Cheers for the info. I'll get the carb apart this week and see what is in there and get some replacement jets bought.

Jonathan Williams

Posts : 19
Join date : 2015-02-18

Back to top Go down

Re: Husqvarna te300 2014

Post by Taffy350 on Mon Mar 09, 2015 11:43 pm

My 300exc is the same set up as Simon's, pretty much spot on if not bang on
avatar
Taffy350

Posts : 2541
Join date : 2013-12-20
Age : 16
Location : Somewhere Bloody Hot.

Back to top Go down

Re: Husqvarna te300 2014

Post by Jonathan Williams on Tue Mar 10, 2015 5:13 pm

Just had the carb apart:
38 pilot
172 main
Nozc needle middle position
1.5 turns out on air screw.


Jonathan Williams

Posts : 19
Join date : 2015-02-18

Back to top Go down

Re: Husqvarna te300 2014

Post by Taffy350 on Tue Mar 10, 2015 5:47 pm

Thats what mine came as standard from ktm. Its was terrible. Try the set up simon mentioned as is mine now. Hell of a difference.
avatar
Taffy350

Posts : 2541
Join date : 2013-12-20
Age : 16
Location : Somewhere Bloody Hot.

Back to top Go down

Re: Husqvarna te300 2014

Post by Jonathan Williams on Tue Mar 10, 2015 5:57 pm

I will give it a go, will get the jets and needles ordered. Can't wait to try a new setup. Will update when I get it fitted and tested. Cheers

Jonathan Williams

Posts : 19
Join date : 2015-02-18

Back to top Go down

Re: Husqvarna te300 2014

Post by Sponsored content


Sponsored content


Back to top Go down

View previous topic View next topic Back to top

- Similar topics

 
Permissions in this forum:
You cannot reply to topics in this forum