Ktm carb

My 300 was using fuel like its no tomorrow. Took carb appart looked at needle it was on second from bottom so went up one notch, much better on fuel now.

Seems to be running fine, do I need to adjust anything else?? Someone mentioned mixture screw? I don't know how you set that up correct??!?

Any help is appreciated, cheers

mixture screw is for only the pilote jet (closed throttle to 1/4 open) buy adusting the clip you have just altered the 1/4 to 3/4 throttle

main jet is for 3/4 to wot (wide open throtle)

i would do a plug chop to see how is burning inside..... does the bike feel more zingy? bike getting hotter than normal?

Bike feels normal no different from beforw

Im running 165 main jet 3rd clip on needle and air mix serew 1/34 turns out and its running fine done that as soon as i run her in

No need to change anything by adjusting the clip on the needle, the main jet will make a difference in how the bike runs, I
took my gasser down from a 180 to a 175' felt very different for the first couple of rides! Seems better on fuel too now.....

I would do what Bonkeye suggests, do a plug chop. If you run it too lean, on a damp day you could seize it.

Plug chop ?

hi. et james set mine up after run in. changed 168 jet to 165
changed n4d j needle for n4d k. needle clip 2nd notch from top. idle screw 1.5 turns out. idle jet left as 35. run like a bag of shit and drank loads of fuel. runs sweet now and better on juice.