Bearing question
+4
phil990
Allmost50
ogri
Robert_G
8 posters
Page 2 of 2
Page 2 of 2 • 1, 2
Re: Bearing question
Robert_G wrote:Small update. I just looked at the bearings that came in my all balls swing arm kit and they are the same hk bearings that are being sold on ebay for 2.19 each. I just paid nearly £43 for the all balls kit too and could of bought everything required for less than £20 if I had bothered to check the sizes and order them seperately as I'm doing now.
Did the ebay bearings come with the inners?
If they didn't, that could be why they are so cheap, you only get the outer race, where the all balls come with the inner bush.
It may have cost a bit more, but at least you can fit, grease and forget now.
Hopes Dad- Posts : 649
Join date : 2011-11-03
Age : 56
Location : Riscashire
Re: Bearing question
Always use aftermarket bearings, never had any problems. Save a fortune.
What tool did you use to tap the old ones out ???
What tool did you use to tap the old ones out ???
Mogs- Posts : 876
Join date : 2011-02-24
Re: Bearing question
Mogs wrote:Always use aftermarket bearings, never had any problems. Save a fortune.
What tool did you use to tap the old ones out ???
I used a 1 ton record vice and a couple of sockets. Came out easily after the initial crack to free them up.
Robert_G- Posts : 28
Join date : 2012-10-19
Location : Nantymoel
Re: Bearing question
Hopes Dad wrote:Robert_G wrote:Small update. I just looked at the bearings that came in my all balls swing arm kit and they are the same hk bearings that are being sold on ebay for 2.19 each. I just paid nearly £43 for the all balls kit too and could of bought everything required for less than £20 if I had bothered to check the sizes and order them seperately as I'm doing now.
Did the ebay bearings come with the inners?
If they didn't, that could be why they are so cheap, you only get the outer race, where the all balls come with the inner bush.
It may have cost a bit more, but at least you can fit, grease and forget now.
No mate, no sleeve with them. Bought the sleeve in a separate auction for £5. I've paid just under £15 in total for the bearings, sleeve and seals.
Robert_G- Posts : 28
Join date : 2012-10-19
Location : Nantymoel
Re: Bearing question
That's a bargain.
Get a good quality water proof grease in them, should last for ages.
Get a good quality water proof grease in them, should last for ages.
Hopes Dad- Posts : 649
Join date : 2011-11-03
Age : 56
Location : Riscashire
Page 2 of 2 • 1, 2
Similar topics
» head bearing removal
» another question on 2 smokes....
» swing arm bearings and rear shock bearing change
» Question ?
» question for wallynut
» another question on 2 smokes....
» swing arm bearings and rear shock bearing change
» Question ?
» question for wallynut
Page 2 of 2
Permissions in this forum:
You cannot reply to topics in this forum
|
|